1.1. Prepare the blind and the necessary tools for installation.

1.2. Unpack the product. Be careful with sharp objects to avoid damaging the fabric and the components of the blind.

1.3. Secure the star-shaped inserts in the brackets.

1.4. Install the prepared brackets on both sides of the blind.

1.5. Align the blind with the desired mounting location. For proper operation, it is recommended to use a level.

1.6. Mark both sides of the product. These marks will be used for installing the brackets.

2.1. Lower fixing kit *

* This kit is not a mandatory element and is not included in the price of the blind; it must be ordered separately.
If you did not order the lower fixing kit, you can skip the following steps marked with *.

* 2.2. The tension cord for the lower fixing must be divided into two equal parts.

* 2.3. Carefully remove the star-shaped inserts from the brackets.

* 2.4. Thread the tension cord for the lower fixing through each bracket as shown, and secure the inner end of the cord with a knot.

3.1. Install the bracket at the marks made earlier, drill holes through the bracket, and secure it with screws from the kit.

3.2. Repeat the same procedure on the other side of the blind.

3.3. Secure the blind with the star-shaped inserts in the brackets.

* 3.4. Install rings for threading the tension cords into the lower clamping strip on both sides.

* 3.5. Thread the cords through the rings on both sides of the lower clamping strip.

* 4.1. Install and secure the tension cord holders for the lower fixing with screws.

* 4.2. Slide the closing element of the cord holder onto the tension cord.

* 4.3. Pull the free end of the lower fixing tension cord and secure it with a fixing screw in the cord holder.

* 4.4. Close the tension cord holder with the cover. The excess cord can be trimmed.