Installation Instructions
On this page you can familiarize yourself with the installation instructions for the roller and blind systems presented on our website.
You need to assemble the hardware for mounting the product. Insert the gear into the bracket (1). Attach the brackets to the roller and position it at the future installation site. Level the product and mark the drilling points. Next, remove the roller with gears from the brackets and secure the brackets to the window frame using self-tapping screws at the marked positions. Reattach the gears onto the roller and install it into the brackets.
To adjust the roller’s height, lower the installed roller to the desired level and mark the extreme lower and upper positions on the chain with fixators (10).
When installing the lower fixation for the roller, thread the cord (16) through the hole in the bracket (1) and tie it in a knot. After mounting the bracket to the window frame, thread the lower part of the cord through the stopper of the lower rail for fixation. Tension the cord to the lower part of the window frame and mark the installation point for the lower fixation fixator (14). Then, thread the cord through the fixator's stopper, secure the fixator to the frame using self-tapping screws, pass the cord through it, fasten it with a screwdriver, and cover it with the cap.
The roller comes pre-assembled, so you should begin with marking. Unpack the roller and position it at the future installation site. Mark the bracket installation points. Then, remove the roller from the brackets by taking out the roller along with the mechanism gears (4). Install the brackets at the previously marked positions, and insert the roller with its gears into the brackets.
To adjust the roller’s height, lower the installed roller to the desired level and mark the extreme lower and upper positions on the chain with fixators (17).
When installing the lower fixation for the roller, create a hole in the bracket (4) through the upper hook's mounting plate (12), thread the cord (20) through the hole, and tie a knot. After mounting the bracket to the window frame, thread the lower part of the cord through the lower fixation ring (16). Tension the cord towards the lower part of the window frame and mark the installation point for the lower fixation fixator (18). Then, secure the fixator to the frame with self-tapping screws, thread the cord through it, and fasten it with the lower fixation sleeve (19) using a screwdriver.
Mountings should be installed in the upper and lower corners of the glazing bead. Place the brackets and mark drilling spots. Fasten the brackets with screws.
To secure the upper locks, click them into the upper installed brackets. Remove the lower locks from the profile and secure them onto the lower brackets. Adjust the tension of the cord and cut off any excess. To close the blinds, simply pull the handle and lock the movable profile onto the upper or lower cord lock.
For the installation of vertical blinds on a wall: Mark the locations for bracket installation (23), approximately 20 cm from the edge of the cornice. Install the brackets onto the wall using dowels and secure the clip (24) onto the bracket. Then, insert the cornice into the clips, install the slats (28) onto the cornice, and connect the lower part of the slats with the chain (22) provided in the package.
For ceiling or upper reveal installation, mark the locations for installing the clips (24). Secure the clips with dowels and install the cornice into the clips. Then install the slats (28) onto the cornice and connect the lower part of the slats with the chain (22).
